![]() ![]() Set all level controls to their least sensitive positions and set all crossover controls, switches, etc. ![]() Recheck all connections before powering up. Insert fuse(s) at the battery fuse holder(s).ġ1. Connect all line inputs and outputs using high-quality RCA-RCA cables.ġ0. If multiple amplifiers are being used, use cables (each with its own fuse at the battery) or a #0 or #2 cable from the fuse holder at the battery to a distribution block at or near the amplifier's location.ĩ. Then make the connection to the "BATT" connection on the amplifier.Ĩ. Make sure there is no fuse in this fuse holder. Connect an empty fuse holder within 300mm (12") of the battery and run 8 gauge of larger high quality cable from this fuse to the amplifier location.ħ. Connect the remote terminal to the remote output of the head unit using 14 gauge wire.Ħ. Keep this ground wire less than one meter (39") in length. Connect the power ground terminal to the nearest point on the chassis of the car. Bolt the amplifier to the mounting surface.Ĥ. Make sure there is sufficient air flow around the intended mounting location.ģ. Find a suitable location in the vehicle to mount the amplifier.Ģ. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |